arvinglass.ir
Inner Segmented Diamond Cup Wheel Q6 for 6-19mm glass. Sinter imported diamond sand. It’s for position two on double edge machine. Sharp, few chips, wear resistant, good balance without shaking or vibrating, high feeding speed. Quickly remove lines caused by previous diamond grinding wheel. It cuts 0.5-1mm glass edge off. Configuration: Pos.1 Full Segmented 100# + Pos.2 Inner Segmented 140# + Pos.3 Continuous Cup 240#
Inner Segmented Diamond Cup Wheel Q6 175*50（Bore）*10*8 + 140#
$112.28
| 175*50（Bore）*10*8 | Specification | |
| 140# | Grit |
Related products
Half V Segmented for Laminated Glass
| 150*12（Bore）*10*12 | Specification |
Diamond Continuous Cup Wheel Q5 150*22（Bore）*8*10 180#
| 150*22（Bore）*8*8 | Specification | |
| 180# | Grit |
Diamond Continuous Cup Wheel Q5 175*12（Bore）*8*8 240#
| 175*12（Bore）*8*8 | Specification | |
| 240# | Grit |
Diamond wheel for four side seaming machine (GOLIVE 25C) 160*10*68*3P10 + 120#+150#+180#
| 160*10*68*3P10 | Specification | |
| 120#+150#+180# | Grit |
Diamond wheel for four side seaming machine (SUNTECH) 150*10*P22 + 320#
| 150*10*P22 | Specification | |
| 320# | Grit |
Diamond Continuous Cup Wheel Q5 175*12（Bore）*8*8 180#
| 175*12（Bore）*8*8 | Specification | |
| 180# | Grit |
Reviews
There are no reviews yet.